Ce-niehoff-co C714 Alternator Retrofit/Upgrade Installation Manuel d'utilisateur télécharger pdf

II0152A

Page 1 of 2

C714 Alternator

Retrot/Upgrade Installation Instructions

This symbol is used to indicate presence

of hazards that can cause minor property

damage.

This symbol indicates special instructions

on installation, operation or maintenance

that are important but not related to

personal injury hazards.

CAUTION

1. Install alternator as shown in Figure 1:

Slip bushing located in rear mounting

foot must be securely tightened

against alternator mounting bracket

on engine. Failure to do so c an result

in broken mounting feet or broken

upper mounting bracket.

On some applications, when replacing

C712 or similar unit with C714, the

installation may require some modi-

fications to existing mounting to

accommodate new C714 alternator.

CAUTION

NOTICE

When replacing an existing A1-704, C711, or C712 alternator, several modifications to existing installation are required,

including replacing the pulley and regulator. READ AND FOLLOW ALL INSTRUCTIONS BELOW CAREFULLY.

a. Use hardened washers between aluminum

surfaces and bolt heads and nuts.

b. Units are shipped with shaft collar, Belleville

washer, and nut installed. Remove and discard

shaft collar.

 • WhenreplacingC714:Installexistingpulley

and furnished Belleville washer. Torque fur-

nished hardware to 163 Nm/120 lb. ft.

  • WhenreplacingA1-704,C711,orC712:

  Replaceexistingpulleywithonesized

  appropriatelyforC714shaftandapplication.

  ContactCENAftermarketSalesDepartment

  forpulleysizing.

Figure 1—C714 Alternator Installation Details



Hardened washer



M12/0.50 Locknut –

torque to

88 Nm/65 lb. ft.

Slip bushing must be tightened against

bracket — see “CAUTION” above



Bracket

on engine

B– terminal bolt M10 x 1.5 (2 places)–

torque to 15 Nm/11 lb. ft.



M12 x1.75 bolt –

torque to 32 Nm/24 lb. ft.

Washer

Battery

output

cable

terminal

Lock washer

Insulator



Alternator B+

Terminal Stud

A2-155

Regulator



1 2

C714 Alternator 1

Résumé du contenu

Page 1 - C714 Alternator

II0152APage 1 of 2C714 AlternatorRetrot/Upgrade Installation Instructions This symbol is used to indicate presence of hazards that can ca

Page 2

II0152APage 2 of 2C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Ser

Commentaires sur ces manuels

Pas de commentaire

Ce-niehoff-co C714 Alternator Retrofit/Upgrade Installation Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Ce-niehoff-co C714 Alternator Retrofit/Upgrade Installation. C.E. Niehoff & Co. C714 Alternator Retrofit/Upgrade Installation User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Ce-niehoff-co C714 Alternator Retrofit/Upgrade Installation